Okay, I have a dumb question and I'm not even sure that it belongs in this thread. It's been a very long time since I've needed to run SetCPU, since I was allowing Pete's script to handle my ondemand CPU scaling automatically in the last ROM, which I ran for quite some time. I have SetCPU set up to autodetect device and set on boot, with 1100 max/250 min. I also have a 100% priority profile set to scale my max down to 800 if my CPU temp gets above 50C. However, every time I reboot, my max resets itself to 800, even though my CPU temp is below the 50C trigger. I tried uninstalling and reinstalling SetCPU and inputting my settings again, but every reboot, I'm back to 800 max, until I actually open SetCPU. Any ideas?
Project Elite 6.5 test/CorCor67 PE 1150Mhz SV
Dual boot from eMMC: CM7/Dalingrin OC kernel at 1350Mhz + Nook Color Stock 1.2 rooted