@Cephraim - I kept getting popups and ignored them but then I got a new refurb so I started from scratch.
For those of you stuck like I was -
I started from stock de03 with 3.1.1 recovery.
Cleared Dalvik Cache and installed 1.8.2.2 to trigger the D106 update. To get the update going.... I went to update Profile>PRL>Firmware in that order (not sure it matters) and after 2 times of it saying No update needed the Firmware finally a popup came and I accepted it. After update it will reboot and install the the baseband D106 but this is the first part of the update (not the build)
To get second part of D106 update:
I then went to boot into recovery and cleared dalvik cache and added 1.9.2 radioactive froyo which is the rest of the update needed for d106. (My understanding is that v1.9.0 and above included second part of D106) Once the phone boots up completely a popup will ask you again to update. Just click install later. It will ask you this quite a few times on reboots but then stops asking (it took me 4-5 reboots for popup to stop).
V.1.9.2 is stable imo however I do have a problem when rebooting where sprint logo/android logo collide until boot. It's a known issue and I am just dealing with it for now until it's fixed. There is a new version V.1.9.3 that I have yet to install.
I was using v.1.8.22 prior to knowing what would happen I installed the update but it only installs the first part and errors when it reboots. I would recommend a clean install and do the steps above I said. The folks at SDX are really helpful!
I hope I explained this clearly as I am not good a explaining things well. I just know what I did to get my phone back to Radioactive Froyo v.1.9.2 with D106 update fully installed. Baseband D106 and Build D106. =)
Also, if this is a pain in the rear... Maybe stick with V.1.8.2.2 or below and avoid pop-up completely by hitting install later.... It's up to you.
|