asmith69

I have a moto droid 1, just flashed cyanomod 7.0.3 successfully, tried to flash to chevy's low voltage and it is now stuck in bootloop with the motoscreen. I can boot to recovery, but the nandroid backup restore isnt working. Any suggestions?

almahix

I often have the identical results with Chevy1's LV kernels, but the medV kernels work great for me. If you can download that you will probably be better off, or try to run the LV kernel at a lower rate. If you can't boot, that might not be easy.

Hopefully you did a nandroid backup before downloading the kernel? If so, flash that back, lower the speed and try to reload the LV kernel. If you didn't backup, reload CM with the stock kernel, then load an alternate kernel.

I like the Chevy1 kernel, but I never seem able to connect my droid to my PC with usb. I don't do that very often, so it isn't a major consideration. There are other kernels that work as well and might still enable usb connection.

northendtrooper

Agree with this^^^
If you still can't get nandroid to work then you might have to bite the bullet and flash back to stock. In nandroid did you go to the advance restore and look in there?

johnlgalt

Since you can get into recovery, connect the phone to your computer, mount the SDCard, download a different kernel to the SDCard and then unmount and flash the new kernel.

__________________

Files for the Motorola® DROID® BIONIC®:
Motorola USB drivers v5.5.0- 32bit | Motorola USB drivers v5.5.0- 64bit | Motorola RSD Lite v5.7