March 17th, 2013, 08:53 PM
Thread Author (OP)
Join Date: Mar 2013
Location: Southern Maine
Device(s): Nexus7 WiFi 32gig
Carrier: Not Provided
Thanked 0 Times in 0 Posts
GrooveIP BlueTooth headset settings
Groove IP Bluetooth headset On Nexus 7 WiFi(perhaps 3G as well)
Here are the settings I use as a phone replacement using a $10 Emerson BT headset model EM128
from BIG-LOTS stores. (I should mention it comes with a Nexus compatible slow charge 200ma charger for home and car and a charge not sync cable)
Step by step assuming you have Groove IP installed and have successfully made a non-headset call.
Any setting not mentioned is default or unchecked.
Step ONE: press the [...
] 3 dots on right top of screen in Groove IP then [SETTINGS
] Put a check in [Accept Calls on Answer
Skip down to [Audio/Echo Settings
] go to [Echo Cancellation
] choose [Basic Echo Canceler
] now go back one step.
Anywhere you find any speaker volumes or Mic Gains set them at midway or 40-50% you might adjust later.
I also check both [Use Contact Ringtones
] and [DTMF Feedback
back out of Audio/Echo settings now.
] check [audio Processing
DO NOT CHECK WiFi Tablet!!! Even if your Nexus is WiFi only.
Check [Synchronize Voice
Next check [Audio Mode Fallback
] then go to [Mic Source
] in that menu choose (Android Default
Lastly I have checked [Disable JB Audio APIs
] any way you want this should not effect BT calling.
Any improvements? Tell me please.
Last edited by Jasonpctech; March 17th, 2013 at 08:57 PM.