APN configuration on Android tablet


  1. sierrawireless

    sierrawireless New Member

    Hi,

    I am integrating Gobi3K modem of Qualcomm in my tablet.
    I can use the Gobi3K modem to make a dial up connection in China. But if I try the same from the Android based tablet, I always get the DHCP error.

    I/RIL ( 1602): requestSetupDefaultPDPQMI IP Address is: 1bf76564 sessionID: 19778216
    I/RIL ( 1602): requestSetupDefaultPDPQMI IP Address: 27.247.101.100
    D/GSM ( 1775): Get PreferredAPN
    D/GSM ( 1775): [GsmDataConnection-1] DcActivatingState deferring msg.what=EVENT_DISCONNECT
    D/GSM ( 1775): [DataConnection] Stop poll NetStat
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 1/0001/16/33
    D/GSM ( 1775): Get PreferredAPN
    D/RILJ ( 1775): NOTE: mReqWaiting is NOT 0 but2 at TIMEOUT, reset! There still msg waitng for response
    D/RILJ ( 1775): WAKE_LOCK_TIMEOUT mRequestList=2
    D/RILJ ( 1775): 0: [67] SETUP_DATA_CALL
    D/RILJ ( 1775): 1: [68] REQUEST_GET_PREFERRED_NETWORK_TYPE
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 1/0002/9/26
    D/RIL ( 1602): signalStrengthCB Signal Strength: -100
    D/RIL ( 1602): signalStrengthCB Radio Interface: 5
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 1/0002/9/26
    D/RIL ( 1602): signalStrengthCB Signal Strength: -100
    D/RIL ( 1602): signalStrengthCB Radio Interface: 5
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 1/0002/9/26
    D/RIL ( 1602): signalStrengthCB Signal Strength: -100
    D/RIL ( 1602): signalStrengthCB Radio Interface: 5
    E/RIL ( 1602): waitDHCPnsetDNS returned error
    I/RILSLQS ( 1671): QM:SDK->Mdm: request received : ipcch/svctype/xactionlen/clientnum: 0/0001/11/0
    I/RILSLQS ( 1671): QM:SDK->Mdm: request validated : ipcch/svctype/xactionlen/clientnum: 0/0001/11/0
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 0/0021/11/28
    I/RIL ( 1602): requestSetupDefaultPDPQMI error handle: Stopped the session 19778216
    D/RIL ( 1602): requestSetupDefaultPDP done
    D/RILJ ( 1775): [0067]< SETUP_DATA_CALL error: com.android.internal.telephony.CommandException: GENERIC_FAILURE
    D/GSM ( 1775): [GsmDataConnection-1] DcActivatingState msg.what=EVENT_SETUP_DATA_CONNECTION_DONE
    D/GSM ( 1775): [GsmDataConnection-1] DataConnection Init failed com.android.internal.telephony.CommandException: GENERIC_FAILURE
    D/GSM ( 1775): [GsmDataConnection-1] DataConnection setup result='Other error' on cid=-1
    D/RILJ ( 1775): [0069]> LAST_DATA_CALL_FAIL_CAUSE
    I/RILSLQS ( 1671): QM:SDK->Mdm: request received : ipcch/svctype/xactionlen/clientnum: 0/0001/4/0
    I/RILSLQS ( 1671): QM:SDK->Mdm: request validated : ipcch/svctype/xactionlen/clientnum: 0/0001/4/0
    I/RILSLQS ( 1671): QM:SDK<-Mdm: ch/QMImsgid/QMImsglen/IPCmsglen: 1/0022/21/38
    D/RIL ( 1602): sessionStateCallback: state=1
    D/RIL ( 1602): sessionStateCallback: sessionEndReason=0

    I feel that the APN and other settings necessary for a GSM network, need to be configured from the GUI. Could you please share the steps on how to configure APN settings for GSM network on my android tablet GUI ?

    With Regards

    Advertisement
    :
Loading...

Share This Page