Node allocation failed

Discussion in 'Application Development' started by meenakshudu, Oct 16, 2009.

  1. meenakshudu

    meenakshudu New Member

    Oct 16, 2009
    Hi All,

    I am working on dspbridge on the OMAP 3430 zoom2 board.

    I downloaded the file system from the net, and copied into the SD card. And I am booting the board with SD card. This file system already has the cexec.out and ping.out executables in the /system/bin folder of the file system. Bridge driver (bridgedriver.ko) is also coming with the kernel. Dsp image ddspbase_tiomap3430.dof64p is also coming with the file system.

    Now I want to run the application.

    I am running the application by following steps.

    1. ./cexec.out ddspbase_tiomap3430.dof64p

    It is showing DSP device is detected.
    Enter any key

    2. ./ping.out 10

    It is telling DSPNode_Allocate failed.

    I did not do insmod operation.

    What should I do now...I dont have source code to debug this.

    Any suggestion is very thankful.

    Meenakshudu B.


Share This Page