overclock wont take effect?


Last Updated:

  1. skytbest

    skytbest Active Member This Topic's Starter

    Joined:
    Oct 22, 2010
    Messages:
    28
    Likes Received:
    0
    So I just rooted my phone, installed Jrummy's overclocker and got all the updates so it works on my droid 2 now. When I go to set a frequency it gives me the little message saying it was successful and stuff but then when I run quadrant it says my processor is still at 1.0 ghz? I set it to 1.4. Anyone know why this is?

    Also, on a side note, I noticed each selection has two frequency for the processor, like 1.4 and 1.1. What does this mean? Does the speed fluctuate between these two speeds at any given time?

    Thanks for the help
     

    Advertisement
  2. Super_Six_Two

    Super_Six_Two Well-Known Member

    Joined:
    Aug 12, 2010
    Messages:
    594
    Likes Received:
    76
  3. skytbest

    skytbest Active Member This Topic's Starter

    Joined:
    Oct 22, 2010
    Messages:
    28
    Likes Received:
    0
    So does Jrummy's just change the voltage?
     
  4. skytbest

    skytbest Active Member This Topic's Starter

    Joined:
    Oct 22, 2010
    Messages:
    28
    Likes Received:
    0
    hmm, for some reason the auto detect wont work, it just says 1000mhz is the max even when I set it to 1350 in jrummy
     
  5. Super_Six_Two

    Super_Six_Two Well-Known Member

    Joined:
    Aug 12, 2010
    Messages:
    594
    Likes Received:
    76
    same is happening to me now. Not sure why...
     

Share This Page

Loading...