Setcpu 2.0.0 Main Profile


Last Updated:

  1. Helenoftroy08

    Helenoftroy08 Well-Known Member This Topic's Starter

    Joined:
    Dec 30, 2009
    Messages:
    266
    Likes Received:
    35
    Im running Pete's virgin deodexed version with Chevy's Low voltage kernel. I have the main setcpu profile set to 900 mhz on the minimum and maximum side, with the performance governor. That works fine and I also have profiles enabled. The profiles work great too. The problem is that when switching from a custom profile back to the main profile, the governor ALWAYS sets to ondemand, and then I have to manually set it to performance where it stays until another profile becomes effective. Any ideas or suggestions? Thanks!
     

    Advertisement
  2. RTAdams89

    RTAdams89 Well-Known Member

    Joined:
    Mar 8, 2010
    Messages:
    101
    Likes Received:
    10
    Not sure, but if you have the min and max set to the same value, does it really matter what the governor is set to?
     
  3. Branndon

    Branndon Well-Known Member

    Joined:
    Nov 10, 2009
    Messages:
    481
    Likes Received:
    30
    That's my thoughts.
     
  4. Helenoftroy08

    Helenoftroy08 Well-Known Member This Topic's Starter

    Joined:
    Dec 30, 2009
    Messages:
    266
    Likes Received:
    35
    You know thats a good question! I was under the impression that even if the min and max were the same, the way the processor moved was different based on the governor, but now that u point that out I could be way off! Wonder how I can find out for sure...
     
  5. sohc sti

    sohc sti Well-Known Member

    Joined:
    Nov 6, 2009
    Messages:
    154
    Likes Received:
    3
    Set a min/Max that's not the same.
     

Share This Page

Loading...