We can now do partial flashes with the CL14 SBL.... If you have not had the CL14 official update yet, you can follow these steps to get it:
Remember... THIS WILL PUT THE CL14 BOOTLOADER ON YOUR PHONE!!!
What you need:
Sprints Update Utility
1. Create a datatool back-up.
2. Download and install Sprints Update Utility found above.
3. Run the program (now called SWUpdater) and follow all the directions until it says "Flash Downloading Complete".
Once you have the official CL14 update on your phone, or if you already had it, and you would like to flash SDX/Joey's Kernel (and Max's Recovery), follow the steps below.
What you need:
CL14 official update
An SDX/Joey's Kernel
Max's Recovery
1. Create a datatool back-up... (Although you most likely wont need it if you are just flashing a kernel.... But JUST in case, you should create a datatool back-up if you aren't confident that you wont wipe your data!)
2. After downloading and installing Sprints Update Utility, go into the binary folder (C:\Program Files\Samsung Electronics\SWUpgrade\Models\Binary) and move the CL14 file to a safe place, MAKE SURE IT IS NO LONGER IN THE BINARY FOLDER.
3. Find the Kernel you want to flash and put it in the binary folder.
Note: Now you should only have one file in the binary folder (the custom kernel). Also make sure that if the file you are putting into the binary folder says 7zip or winrar, extract it!! If you dont you will get the message "Cannot access bin folder!", and you will not be able to start the download.
4. On your desktop there should be a program named SWUpgrade. Run the program and follow all of the steps through the end. After every thing finishes successfully, you will end up with STOCK CL14, this includes the CL14 SBL, along with the custom kernel you put in the binary folder (you are root).
5. Double check that everything worked by going into Settings-About Phone, under BaseBand version you should see S:M900.8.0S.CL14, under Kernel version= 2.6.27 moment(at)momentdev, under Build number= Joey's name (or any other developer who's kernel you put in the binary folder).
6. Repeat steps 1-4, putting Max's recovery in the binary folder instead of the kernel.
7. You're all set.
(If you happen to want to flash one of Zefie's kernels, repeat steps 1-4 also.)
It wasn't a great thing to get the CL14 update before, because it was hard to obtain root. But now with Sprints Update Utility, and all the new kernels, we are able to get root with the CL14 SBL easily.
