How do I dirty flash? I installed 147 this morning and have been using it all day, but I wish to upgrade to 155. The dev said to dirty flash...do I just flash it without wiping anything?
guess there's a first time for everything?
I wiped system, cache, data, and dalvik, then installed the ROM, then rebooted.
Can't do it any better than that.
Ah well, went back to my 'Beans file, then onto Eclipse with zero issues.
guess there's a first time for everything?
I wiped system, cache, data, and dalvik, then installed the ROM, then rebooted.
Can't do it any better than that.
Ah well, went back to my 'Beans file, then onto Eclipse with zero issues.
BEWARE: Battery overheating on r155 & r167. The latter was 30% better, but still overheats.
.
.
Sent from my $.96 GS3
-CleanROM 5.5.1
-Gorilla Gadgets 4500mah Battery
-ZaggShield & skin
BEWARE: Battery overheating on r155 & r167. The latter was 30% better, but still overheats.
.
.
Sent from my $.96 GS3
-CleanROM 5.5.1
-Gorilla Gadgets 4500mah Battery
-ZaggShield & skin
Installed v169 yesterday. So far so good. After getting it set up 'like I like it' and charged it overnight battery life looks promising. Took 2.5 hours of standby (little or no use) to go from 100% to 99% this AM.
I did have heating issues yesterday, but I was downloading from the play store, etc. It's fine this morning. I didn't like that it's overclocked to 1900Mhz, so I used ROM Toolbox to back it down to 1500Mhz. That may be part of the heating issue, not sure.
Installed v169 yesterday. So far so good. After getting it set up 'like I like it' and charged it overnight battery life looks promising. Took 2.5 hours of standby (little or no use) to go from 100% to 99% this AM.
I did have heating issues yesterday, but I was downloading from the play store, etc. It's fine this morning. I didn't like that it's overclocked to 1900Mhz, so I used ROM Toolbox to back it down to 1500Mhz.
I had some heat issues with Ziggy's kernel too. When I went to system tuner I found that it was clocked at 1.9 MHz and the governor was set to lag free. When I toned it down it helped with the heat issues but I still ended up flashing Lean kernel. I find the battery life is a little better and no heat issues. I'll go back to Ziggy's in the next release.
I, also, did the toggle USB debugging tip? I think that helped out too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.