For Bluetooth and headset (plugged into stereo)
- Playback gain: extreme, 4x, 0 dB offset
- Adjust EQ
- Differential sound: 20 ms
- Reverb: 36m2, 6m, 10, 20, 70
- Bass boost: natural, 50 hz, 8 dB
- Viper clarity: XHiFi, 6 dB
Differential and Reverb set like that give an awesome, clean sound, with a great feel (sound stage). Overall the music becomes ALIVE, no muddyness.
I thought that I should expound on why I chose those settings, just so what I'm doing makes more sense to others.
Playback gain is set to extreme for full effect, otherwise IMHO setting it to slight or medium only affects only part of the frequency range available.
4x to boost the volume without acquiring any distortion, setting any higher distortion becomes prevalent.
0 dB offset is for not diminishing the boost in volume in anyway, I would only use (-) dB offset for when I use actual headphones.
Adjust the
EQ to your liking, pretty self explanatory
Now the
differential offset of 20ms works in conjunction with the reverb settings. Choosing 20 ms was critical for pulling the mid range back into the sound that becomes missing or shoved into the background from using the reverb, it seems to soften out and become lost if not turned on (the other ms choices don't seem to enhance it properly). There is a loss of richness/warmth/fullness in the middle range as well without having it set at 20 ms.
In the
reverb settings I found through experimenting that the
sound field size should be in a semi-direct proportionate ratio to room size, that way it gives an even dispersal of the sound stage. I chose
36 m2 for a room size to open the sound stage without spreading it too wide. So for picking sound field size I went with
6m, 6 x 6 = 36.
For choosing a larger room size just adjust it accordingly, meaning if you chose: 64m2 you would use 8m, 81m2 use 9m, 100m2 use 10m, and so on. Now onto the other reverb settings. I picked these (10, 20, 70 = 100) to control the feel of the reverb. The
dampening factor acts like a mute on the reverb. The
wet signal is the amount of reverb applied over the original sound, setting this too high gives a sense of losslessness (adds an echo like swirl feeling, setting the sound stage outside desired listening parameters). The
dry signal is the amount original sound to be used, how dry or tight the final reverb effect is presented.
Bass boost I leave at natural to keep all the bass sounds intact without bottoming out, just a personal choice
. I'm personally not thrilled with how the other 2 choices influence the bass.
50 Hz seems to be average for most systems/speakers to control the start of the "sub" side, setting other than this seems to push the bass into the wrong frequency range.
8 dB to bring the lower end into focus with just enough boost.
Viper quality I enable XHiFi for the full effect. It takes the upper frequency range and makes all the subtle sounds that were suppose to be heard noticeable again. This works especially well with recordings that sound somewhat
muffled and improperly mic'd.
6 dB to get those muffled sounds to the right level, going above makes the sound brassy and too edgy for enjoyable listening.
Although setting higher with bad recordings this can work beneficial to get the high range "audible".
I hope my addition to my previous post provides help on setting Viper4Android quickly, plus give some explanation to what the settings I chose do.
In no way is this official information. I have been in and around the music industry for awhile, "the sound guy" is one of the positions I have always enjoyed, so if I help any to get better sound from their device then I have accomplished my goal.
If anyone has a question about the other settings available within Viper, just ask. PEACE