One of my hobbies is deejaying and I prefer to use an MP3 file at 320kbps instead of WAV to save a little disk space. You might try bumping your music files up to 256 or 320kbps. If you are using 128kbps or less, you should notice a change in how loud it is. I can tell a different. I used to put 128kbps songs on my phone a long time ago, but I could hardly hear them when I mowed the grass. Listening to 256 and 320 was much louder and I could hear it over the mower's engine.
get "audacity" from soundforge. you can take your mp3 files, and increase the volume on them and re-save the files. However watch the signal spectrum because if you let the signal reach the top of the little graphic it will be "clipping" in other words too loud to where it causes distortion.
get "audacity" from soundforge. you can take your mp3 files, and increase the volume on them and re-save the files. However watch the signal spectrum because if you let the signal reach the top of the little graphic it will be "clipping" in other words too loud to where it causes distortion.
I forgot about mentioning Audacity and MP3Gain. I'm using the MP3Gain to level out all my music files so when I mix, they all are very close to the same sound output and don't have to adjust the Gain knobs on my mixer. I'm also using Switch Sound File Converter to raise and lower bitrates.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.