• After 15+ years, we've made a big change: Android Forums is now Early Bird Club. Learn more here.

Help Moto 360 System Update thread

How do you turn off unused features?
How do you turn off unused features?
I tapped the screen, went to Start, then I opened all the stock apps one by one. I slid my finger from right to left to access the settings for each app once it opened. On some apps you have to slide from right to left 2-3 times to access the app settings. Just slide until you reach the last screen because that's where the settings tend to be located for the app. Turned off the following apps: Fit, Moto Body Calories, Moto Heart/Body Activity (only allows notifications to be turned off). And Moto Body Steps (only permits notifications to be turned off.)

When did the wear app give us the ability to see battery usage? That's really cool. I'm not concerned about battery life anyway. Just FYI, if you are taking a road trip and using your watch with your phone you can expect to get 8-10 hours out of it. So bring your charging stand especially if you plan to use your watch for turn by turn directions for that entire span.
 
Last edited:
Upvote 0
Mine was doing that last night. I did a reset this morning. I found a post on G+ about the same thing, he did a reset. It's clearly an issue, but not widespread. Hopefully it will be OK when I charge it tonight.

The funny thing is that my watch updated last week and has been fine up until last night.

Edit: Are you using WatchMaker? Now I'm reading that this issue may be that, not the watch. Ugh. That makes more sense as far as timing goes...

Edit edit: Yeah, it's WatchMaker. I just popped my watch on the charger and it blinked. Changed to a stock face and it stopped.
 
Last edited:
  • Like
Reactions: shalemail
Upvote 0
No, not exactly.

WatchMaker can (not for everyone apparently) make the charging screen pulsate/flash while charging. It fades from from bright to dim and then goes back to bright, it never settles down.

A non-WatchMaker face will go from bright to dim. End of chat. If you activate ambient on Wear then uncheck it it will shut the display off. You can't do that with WatchMaker right now, it just flashes/pulses away.
 
  • Like
Reactions: shalemail
Upvote 0
Here is what I found last night (might be a repeat)
I am currently using a watchmaker face and Development options enabled so I Set Stay awake to 'Disabled'

- set on charger
- shows charging face
- dims then goes blank
- approx 1 second later screen comes on.. stays on
- if I set it to a Moto Face
- Place it back on charger
- then toggle Ambient mode on and off the screen goes bank and stays off

I found if I enable the 'Stay Awake' the Screen stays bright (with the watchmaker face)
 
  • Like
Reactions: Clementine_3
Upvote 0

BEST TECH IN 2023

We've been tracking upcoming products and ranking the best tech since 2007. Thanks for trusting our opinion: we get rewarded through affiliate links that earn us a commission and we invite you to learn more about us.

Smartphones