I got my i-blason case in today, and am more than a bit disappointed in the overall quality.
1. The side flap causes the left (inside) part of the case where it folds underneath to velcro in to bulge out significantly farther than the outside.
2. As a result of item 1, the flap will not close easily. You need to first hold the binding flush against the bulging edge, THEN close the top flap. This design is unwieldy, feels sloppy, and reminds me of a tattered hardcover book that has it's binding glue all dried out.
If you attempt to flip it close with just the primary cover, it stays open by at least 30 degrees. At this point, if you push the binding flush, it still does not close on it's own, but still has about 15 degrees to go. Only by then pushing down on the cover can it close on it's own.
3. The viewing area was not cut square! Unfortunately, I do not have a camera handy, but this isn't even CLOSE. The opening is not a rectangle, but rather a very poor parallelogram. Turning the brightness all the way up, I can see the unevenness at the top and bottom of the screen. On the left, the screen goes so far as to be partially obscured at the bottom left! Pushing the tablet different ways to make sure it is fully seated does not correct this a bit, it just shifts the skewing a hair more to the right.
Short version: This case is horrible, and I will be returning it ASAP.